Titán Multi -Purpose Primer 125ml Anticorrosive quick-drying primer for all kinds of surfaces. Excellent adhesion on a great variety of materials. Protection against rust on iron surfaces. Adhesion primer for surfaces such as: galvanized (zinc plating), aluminium, steel, brass, copper and zinc. It improves adhesion on hard PVC, melamine and ceramic surfaces. When painting tiles submitted to high humidity, a base coat of Multi Purpose Primer provides excellent adhesion. Do not apply on expanded polystyrene. Direction of Use: GENERAL REMARKS: Stir well in the pack before using. The surfaces to be primed have to be clean and dry, as well as free from grease and rust. BARE SURFACES: Steel: Remove rust by means of a wire brush or sandpaper. Get rid of grease, dust and rust residue. Galvanised, PVC, Zinc, Steel, Brass, Aluminium and Copper: Wash with water and ammonia detergent. Softly sand to improve adhesion. Apply 1 coat of primer. For very humid areas, apply at least 2 primer coats. Wood: Sand wood following the wood grain, thoroughly clean, remove all resins or resin secretion on the surface and smooth up sharp edges. Apply 1 or 2 coats, depending on absorption. Softly sand between every two coats if a smooth finish is required. For wood outdoors, previously apply Titanxyl Ultra Total Protection. It is possible to apply a second coat of this primer or topcoats of alkyd enamel after 2 hours. For topcoats with two component products (epoxy or polyurethane), they have to be applied observing a delay of 24 hours after the last coat of TITAN MultiPurpose Primer. Indoors: apply 1 coat of TITAN Multi-Purpose Primer. Outdoors: apply 2 coats of TITAN Multi -Purpose Primer. ALREADY PAINTED IN BAD CONDITION SURFACE MAINTENANCE: Completely remove all previous coats and proceed as for bare surfaces. Precautions before using the product: Always read the pack label before use. For more information, please refer to the Safety Data Sheet.